Chronos Calibration instructions and profiles

CHRONOTIMER CALIBRATION ROUTINE

Updated for ChronoTimer

(to exit the calibration routine hit RESET)

Click here for the Calibration Profiles that I use on each system.

(TIP, if you find it hard to make a selection with the adjustment dial due to flicker, set the display brightness to about half and try again it should smooth things out)

READ BEFORE PROCEEDING          

Instruction manuals

ChronoTimer 1.3 Manual

Download

CALIBRATION INSTRUCTIONS ARE ON PAGE 4.

IF THIS IS YOUR FIRST TIME USING THE CODE, IN ORDER FOR IT TO WORK PROPERLY ENTER THE CALIBRATION MODE AND LOAD THE DEFAULTS.

MODE DIAL = POS.

PRESS <- and  SET

PRESS > UNTIL SEE DFLT, THEN PRESS SET. LET IT RUN ITS COUNTDOWN, WHEN IT IS FINISHED RESET THE SYSTEM

NOW ALL THE PARAMTERS SHOULD BE BURNED IN AT FACTORY DEFAULT. THE SYSTEM CAN BE USED.

The Chronos Project | Time Lapse Motion Control
©2013