Forum

Welcome Guest 

Show/Hide Header

Welcome Guest, posting in this forum requires registration.





Pages: 1 [2]
Author Topic: My Chronos 2 Controller Box Build - Issues
graphectio-
ns
Newbie
Posts: 10
Permalink
Post Re: My Chronos 2 Controller Box Build - Issues
on: January 30, 2014, 19:25
Quote

Hi Chris, I just emailed you hi-res photos.

I dont have a Multimeter but can get one.
As for the display, as I mentioned I get garbled display when using a 12v battery and zero display with USB power. (noted about uploading sketch with display attached - so upload sketch to arduino without shield attached, power off attached sheild again and use 12v battery or plug back into USB from computer so I can read serial display monitor values?

I have tested the display on another Adruino using basic code and it still works fine.

The Black wire goes from Mode POT left pin > Adjust POT left pin > from there is goes to ground on Protoshield (pots are displaying values on test sketch)

graphectio-
ns
Newbie
Posts: 10
Permalink
Post Re: My Chronos 2 Controller Box Build - Issues
on: January 31, 2014, 01:03
Quote

I got a multimeter and tested Pin 1 and the header pin going into the Arduino.
At 2k setting on the Multimeter - it was 0 and at.200 I got a 0.1
I assume this is tollerable?
Arduino + shield powered by Computer USB only.

graphectio-
ns
Newbie
Posts: 10
Permalink
Post Re: My Chronos 2 Controller Box Build - Issues
on: January 31, 2014, 01:06
Quote

At 5v and ground connections on Display I got zero as well.

This is new to me :) But i like it lol

Pages: 1 [2]
The Chronos Project | Time Lapse Motion Control
©2013