DIY Chronos Standard Kit

Kit Deluxe


Out of stock

Product Description

Available for pre-order, we will start shipping in early April.

Building your own Chronocontroller is a very ambitious project! While we have step by step instructions, it is still quite a feat, and there is a lot that can go wrong. That is why we are excited to offer a new line of DIY Chronocontroller kits designed to make things a bit easier. The Protoshield has been replaced with an all new Chronos Breakout Board that is clearly labeled and gives direct solder points for the display, buttons, inputs and outputs. Just solder the Optoisolator, motor driver, and resistors to the Chronos Breakout Board,ot only will it remove a lot of the work, but it will remove a lot of possible failure points as well!

The Standard kit includes everything for your own enclosure! (Soldering required)

Chronos Breakout Shield
Motor Driver
Header Pins
Heat sink
Seven Segment Display
4 buttons
Audio Jacks
Hookup wire (single color)

(Arduino, Db-9 jack, and enclosure not included, photos shown with typical ABS project box)

Additional Information

Weight 1 lbs
Dimensions 6 x 6 x 6 in


There are no reviews yet, would you like to submit yours?


7 × = thirty five

The Chronos Project | Time Lapse Motion Control